I need to match the height of the existing tile in the bathroom.
Do i need a sub floor for cement board.
I plan on thinsetting and screwing cement board to the subfloor then redgard then thin set and tile.
And then once the cement board is down and it s screwed in do i have to put some type of mesh tape to put the boards together and then mortar the tape.
So first of all if you re going to put down durock which is sort of that cement board that you re describing generally that s screwed down.
When installing a ceramic tile floor on a concrete subfloor you don t have to worry about flexing as long as the concrete slab is at least 1 1 8 inch thick which most slabs are.
Cement board a sheet of lightweight concrete and fiberglass mesh should be laid over top of the subfloor for any tile project.
Cement backer board is more dimensionally stable than plywood and forms a better bond with the thin set adhesive used to glue the tile down.
It depends on the sub surface if it is a concrete slab then no but if it is a plywood decking yes.
The primary benefit of cement board is that it doesn t break down or expand or warp if it gets wet.
If the subfloor doesn t have enough stability you can usually but not always remedy the situation by installing cement backer board also called cementboard.
So you would screw that down to.
Cement board also provides an additional layer over a plywood or particleboard subfloor adding stiffness to the tile.
Here s the right way to attach cement backer board to a plywood subfloor.
If it is a planked floor then y.
Cement board is a type of underlayment that is now standard for most tile installations but particularly for floor tile.
If it is vinyl tile glued over a concrete slab you can clean the tile and adhere the tile directly to the vinyl.
Make sure the joists are wide enough for the span and spaced on 16 centers to provide a sturdy floor with no bounce.
Apply a supporting bed of mortar or modified thinset to subfloor using a 1 4 square notched trowel.
Would this calculation get me to the right height compressed thin set on top of sub floor 1 8 cement board 1 2 compressed thin set on top of cement board 1 8.
The plywood subfloor should be at least 5 8 thick on 16 centers 3 4 preferred and securely attached to the joists preferably with screws.
It strengthens the floor removes bounce and gives the tile a.
They skipped putting down the thin set under the cement board even though the installation instruction specify that it is required.
Precut and fit all the cement board and then lift all of the cement boards out.