Garden answer youtube.
Diy gutter planter.
The front and back of each gutter piece will have 2 holes.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.
Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
Start by drilling the bottom holes using your drill and 3 8inch bit.
Measure 12 inches of.
For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.
Tie a knot at one end of the 10 foot rope.
This will lock each segment along the suspension wire.
Garden answer youtube.