Cyclone How To Adjust Tension On Electric Awning

How to adjust awning arms www awningdepot co uk.

Cyclone how to adjust tension on electric awning.

Push the aluminum pole in its extended length up to the rv wall and down to the lip of the awning under the awning itself. Position so the pole pushes the awning out adding tension to the fabric. Special aluminum poles often accompany the rv awning for this use. The tension arms are what you adjust to make the awning taut after it has been lowered.

Since this is the side with the ratchet catch the awning might try to roll up on you some just tell your helper to hold it tighter. Remove the 2 phillips head screws from the bottom end of the outer section. 2 the support arm consists of an outer and inner section. See our channel page for link the home on the road series consists of three 2 dvd.

In this event just place the crank into the socket and begin to spin it until the awning is the right size. Facing the awning the arm on the left has the rewind spring. Others might require you to use a hand crank extended device. Loosen the left arm pull it out just enough to clear the slide.

One turn may give you the desired tension. Standing at the front of the awning and facing the rear you need to rotate the front awning leg counter clockwise. If not turn arm one more turn. This should increase the tension on the awning.

Some have electronic motors that will allow you to adjust the awning automatically with the push of a button. Eventually you should get it to rotate all the way around. With great ease turn the arm counter clock wise. Be very careful there is a lot of tension on the arm.

Place the step stool near the lip of the awning.