Irrespective of how you will be cutting the stainless steel you will have to prepare.
Cutting stainless steel sheet by hand.
It s a handmade tool that sets around a stainless steel tube and cuts it with a small rotating wheel.
Mark on your stainless steel sheet with a permanent marker or metal scribe where you want to make the cut.
How to cut stainless steel step 1.
Cut the stainless.
Insert your stainless steel tube into the tube cutter.
We ll give out a guide for using all three tools here.
Step 3 place the edge of the stainless steel all the way inside the jaws of the snips and cut along the line that you marked.
Take a center punch and use it.
This will help you in the upcoming frilling process.
Keep rotating the knob until the tube is secure.
Prepare your work area.
When the tube is set up fix it into place by rotating the knob at the end of the tool.
Now let s go through the steps of using a punch set for cutting stainless steel step 1.
Compound snips also called aviation snips are color coded.
This will burn through the steel plate on contact and allow you to cut along the mark.
If you don t have one then get one.
Using a circular saw a circular saw can come in handy for cutting through pieces of steel too thick for tin snips or power shears.
The cutters are offset below the handle so you can keep your cutting sheet metal hand above the work and the compound action allows you to cut thicker material with less effort.
Mark your center and diameter.
Once your tube is in position tighten it into place by rotating the knob at the end of the device.
Utilize your tape measure to obtain a precise measurement for the steel that you need to cut.
A plasma cutter does yield a smoother cut than a circular saw or a cut off saw.
Use a tube cutter specially made for stainless steel.
You will get punch sets made especially for cutting stainless steel.
Do not press down all the way on the snips as this will make a jagged edge.
So let s move on cutting with punch sets.
Start by placing the cutting end of the torch about three inches away from the surface of the steel and start the cutter.
You can also use a plasma cutter for cutting holes in stainless steel.
Mark the surface you want to cut with the disc on the cutter.
