The board has two sides.
Cutting board with a gutter around the edge.
Mark the line on your board so you know where to make your cut.
Work wrinkles and bubbles flat.
Cut the board into 3 ft 0 91 m sections with a reciprocating saw.
Use a carpenter s square to get around to the bottom.
Mark out 3 ft 0 91 m sections along your fascia board with a pencil.
Laying your gutter on the workbench measure off the amount of gutter you want to cut and mark it with a pencil.
Gutters that are too high can enable runoff water to drip down their back side which in turn can cause deteriorating fascia boards and stains on siding.
Then with the combination square transfer the line down each side of the aluminum gutter.
Cut the boards to length you need using a circular saw.
Extend the cut mark around the aluminum gutter by aligning the blade of the combination square with the length mark you placed on the bottom surface of the aluminum gutter and running the carpenter s pencil along the edge of the combination square blade.
You might try to slope your gutters correctly but improperly positioned gutter hangers can foil those plans and cause your gutters to sag in the middle.
One is smooth while the other has a depressed gutter around the edge to ca ture drippings when cutting meat.
Roll the tape down the wall of the gutter pushing it firmly into curves and corners photo 3.
Tear the paper backing off the tape and lightly adhere one edge of the tape to the top of the gutter.
Put on safety glasses before turning on the saw and pushing it through the board.
Cut the tape with a scissors or a razor knife photo 2.
Use the old adage measure twice and cut once then turn the gutter upside down on the table and mark it all the way around.
Most cutting boards slide on the counter when i cut tough foods and i usually need to put a dish cloth under them to prevent slippage.
Bend bracket as required to ensure correct fi t.
Make vertical cuts into the fascia board between your roof rafters.
When fi xing edge gutter to timber fascia ensure the bracket is secured using a minimum of two self drilling timber screws into the rafter.
Lay the board you re cutting on top of 2 saw horses so the side your cutting hangs over the edge.
